Vector Sensor Reference Manual 71
$>JSHOW,CONF Message header
N ‘N’ indicates no altitude aiding
0.0 ‘0.0’ indicates the aiding value, if specified (either specified height
or PDOP threshold)
10.0 Residual limit for the $JLIMIT command
5 Elevation mask cutoff angle, in degrees
A AIR mode indication
60 Maximum acceptable age of correction data in seconds
W Current differential mode, ‘W’ indicates WAAS mode.
When GP is specified for ‘subset’, the following is an example response provided.
$>JSHOW,GP,GGA,1.0
This response will provide the >$JSHOW,GP message header, followed by each message currently
being output through the current port and also the update rate for that message.
6.3.16 $JT
This command displays the type of receiver engine within the Vector Sensor and has the following
format.
$JT<CR><LF>
The receiver will return the following response, indicating that the receiver is an SX1a (‘a’ for
attitude system) when in.
$>JT,SX1a
6.3.17 $JI
This command displays Vector Sensor receiver information. It has the following format
$JI<CR><LF>
The receiver will reply with the following message.
$>JI,11577,1,5,11102002,01/01/1900,01/01/3003,1.1,38
This command is summarized in the following table.
Message
Component
Description
To Next Page
Loading...
Need help?
General
