CSI MS32V-S3 - Softener Specifications; General Specifications Overview

3
WARNING
Lubricants
Do NOT use Vaseline, oils, hydrocarbon lubricants or spray silicone anywhere! Petroleum base lubricants will cause
swelling of o-rings and seals. The use of other lubricants may attack plastic Noryl®. It is recommended that Dow
Corning® silicone grease be used as a lubricant for all control valves. Dow Corning® 7 Release Compound is used in the
manufacture of Chandler Systems control valves. (Part # LT-150)
Sealants
Pipe dope and liquid thread sealers may contain a carrier that attacks some plastic materials. It is recommended that
Teflon® tape be used to seal plastic Noryl® threaded fittings.
Softener Specifications
General Specifications
MS24-S2
MS24V-S2
MS24-S3
MS24V-S3
MS32-S2
MS32V-S2
MS32-S3
MS32V-S3
MS48-S2
MS48V-S2
MS48-S3
MS48V-S3
MS64-S2
MS64V-S2
MS64-S3
MS64V-S3
MS96V-S2*
MS96V-S3*
Grains Capacity -
Regeneration / Lbs Salt Used**
24,000 / 12
20,000 / 7.5
15,000 / 4.5
32,000 / 15
27,000 / 9
20,000 / 6
48,000 / 24
40,000 / 15
30,000 / 9
64,000 / 30
54,000 / 18
40,000 / 12
96,000 / 45
81,000 / 27
60,000 / 18
Maximum Raw Water Hardness (grains) 50 75 100 100 100
Maximum Clear Iron / Manganese 3 5 5 5 5
Exchange Resin (cu ft per tank)
.75 1.0 1.5 2.0 3.0
Mineral Tanks (polyglass) 8 x 44 9 x 48 10 x 54 12 x 52 13 x 65
Brine Tank (polyethylene w grid & safety) 18 x 33 18 x 33 18 x 33 18 x 33 18 x 40
Service Flow Rate (gpm per active tank)*** 8.0 10.0 11.0 12.0 14.0
Backwash Flow Rate (gpm) 1.5 2.0 2.4 3.5
Gallons Used / Regeneration 79 90 101 140
Backwash Flow Rate (gpm) Vortech (V) Units 1.2 1.5 2.0 2.4 3.0
Gallons Used / Regeneration Vortech (V) Units 69 78 90 117 126
Space Required
18 X 26 X 53 18 X 27 X 56 18 X 28 X 62 18 X 30 X 60 18 X 32 X 74
Approximate Shipping Weight (lbs) 88 100 133 164 285
*96 Series only available in Vortech Units
**Factory Salt Settings are 9 lbs / cu ft
***The pressure drop does not exceed 15 psi at the service flow rate