Chapter 2. Installation
23
November 2001
ET10 10BASE-T Interface connector
Appendix A.9 describes the cabling connection and DIP switch
settings for the Ethernet Bridge interface.
ET10R 10/100BASE-TX Interface connector
The Ethernet connection for the ET10R module is a standard
MDI, shielded RJ-45. A separate electronic manual (in PDF
format) is provided with this module to cover setup and
configuration of the router functions.
Cable and Termination
Use a shielded twisted pair cable between the ETU-01A and the
DTE device. The receivers on the ETU-01A are 100 Ohm
terminated (For X.21 and RS-530). If problems are encountered
with the connection to the DTE interface, make sure that the DTE
interface is terminated correctly.
To Next Page
Loading...