Chapter 3. LCD Operation
27
November 2001
3.1 General
This chapter describes the ETU-01A controls and
indicators, and explains operation setup procedures. Installation
procedures (in Chapter 2) must be completed and checked before
attempting to operate the ETU-01A.
3.2 Controls and Indicators
All controls (push-button switches), LCD display and LED
indicators are located on the ETU-01A front panel. The
momentary on pushbutton switches are used to activate menu
selections and select parameter settings.
Figure 3-1 : ETU-01A Front Panel
Use the ‘<’ and ‘>’ arrow keys to browse the menus and select
parameters. Use the ‘ESC’ function key to return to a previous menu or to
abandon setup. Use the ‘ENTER’ function key to set a parameter of a
selection or to enter a sub-menu.
To Next Page
Loading...