What to do if my CTR Kheos Plus Industrial Equipment vacuum pump is not working?
If the vacuum pump on your CTR Industrial Equipment isn't working, there are several potential causes. First, there may be gas in the circuit, in which case you should perform a recovery phase. Second, check the power supply and fuses to ensure the pump is receiving power. Finally, the pump itself may be damaged and require replacement.
What to do if my CTR Industrial Equipment unit is not recovering?
If your CTR Industrial Equipment unit is not recovering, a possible cause is a blown fuse. Check the fuse in the recovery compressor/solenoid valve on the circuit board. Another potential cause is a damaged recovery compressor, which would need to be replaced.
What to do if CTR Industrial Equipment shows error E4 - Vacuum time expired?
If your CTR Industrial Equipment displays error code E4, indicating that the vacuum time has expired, it means that the -0.75 Bar threshold cannot be reached. In this case, you should check the integrity of the system and connection pipes.
Information on obtaining and installing replacement parts for the unit.
Describes the primary operations the unit can perform, such as recovery and vacuum.
Specifies requirements for the operational area, including lighting and ventilation.
Recommended checks to perform before starting the unit's operation.
Instructions for proper waste disposal of electrical and electronic components.
Critical safety information regarding refrigerant handling and potential hazards.
Explanation of the system used to secure the refrigerant cylinder during operation.
Description of the control panel, including buttons, gauges, and indicators.
Overview of the sequence and flow of operations for optimal results.
Service functions accessible to trained operators for unit customization.
Step-by-step guide for replacing the unit's refrigerant filter.
General| Brand | CTR |
|---|---|
| Model | Kheos Plus |
| Category | Industrial Equipment |
| Language | English |
To Next Page