LUBRICATION/FILTERS/FRUIDS
102
FRONT AXLE LUBRICATION (MFD)
Service Specifications
Oil Change Interval Every 200 hours (See NOTE)
Oil Capacity 4.0 Liters (4.2 Quarts)
Oil Type SAE 85W-140 Gear Lubricant
NOTE: Change the oil after the first 50 hours of operation and then every
200 hours of operation.
Front Axle Oil Level
To check the front axle oil level, put
the tractor on level ground. Remove
the oil level plugs located on the rear
of the both gear cases. If the oil level
is low, add the recommended oil type
through the fill hole located on the RH
side of axle housing until the oil
begins to flow out of the level plug
holes.
OIL LEVEL PLUG
DRAIN PLUG
To Next Page
Loading...
Need help?
General