Cubicon Single Plus - Page 59

CUBICON Single Plus User Manual
59
11) Printing cannot be processed due to auto leveling failure.
 Check if environmental vibration affects equipment in auto level process. Auto level may fail in the case
of vibration transmission to equipment.
 The printer proceeds auto level of bed in prior to print. The printer stops printing in the case of auto
leveling failure (automatically proceeding for several times) due to some reason.
 Make sure to maintain auto level contact point continuously.
 In the case of continuous problem occurrence, replace extruder cleaning brush or heating bed by A/S.
 Auto leveling may fail depending on temperature and filament difference in non-genuine filament use.
12) The presence detection sensor of filament is not operated properly.
 Make sure to check supplying filament’s diameter is 1.6~1.9mm in prior to use it.
 Flexible filament such as TPU may malfunction due to filament pressure to supply detection sensor.
Make sure not to use filament supply detection function in this case.
(Setting > Function > Filament Check “Off”)
 The filament detection sensor may get worn out due to continuous use as it is consumable material.
Replace the presence detection sensor through A/S.
13) Operation stops in printing process.
 Check power supply.
In the case of continuous problem occurrence take a photo or video of problematic part and use A/S.