Wired Touch Panels - User Manual
17© CUE, a.s. | All Rights Reserved.
ConneCtIon
Ethernet
The 10/100 BaseT LAN is a standard network connection 10/100 BaseT LAN using RJ-45 connector. There is no auto
sense, which means it does not recognize straight through cable to cross-over cable. For the direct PC connection it is
necessary to use cross-over cable; for the connection to Ethernet switch straight through cable. The length of the Ethernet
cable connecting touch panel to the network must not exceed 100 meters.
Power over Ethernet is fully compatible with
• IEEE 802.3af (PoE) standard for 4.3” and 7” models
• IEEE 802.3at (PoE Plus) standard for 12” models.
Power over Ethernet integrates data and power on the same wires. It keeps the structured cabling safe and does not interfere
with concurrent network operation.
Power over Ethernet needs compatible Ethernet switches or injectors currently available by most leading network equipment
vendors.
Ethernet without PoE Infrastructure
Power supply
PoE Adapter
OUT IN
Ethernet cable Ethernet cable
Ethernet
Ethernet with PoE Infrastructure
Ethernet cable
Ethernet
with PoE
Connector pin out
RJ-45 Pin Signal Cat5 Cable Color
1 TX_D1+ and PoE White / Orange
2 TX_D1- and PoE Orange
3 RX_D2+ and PoE White / Green
4
PoE +/- 48 V
Blue
5 White / Blue
6 RX-D2- and PoE Green
7
PoE Common
White / Brown
8 Brown
To Next Page
Loading...