Cuisinart FP14DCE - Use; Fitting the Work Bowls; Removing the Work Bowls

26
3. USE
A. Fitting the work bowls
Please wash all the accessories and the bowl carefully before
using for the rst time.
CAUTION: be extremely careful when handling the sharp
accessories.
NOTE: You may nd the bowls dicult to handle the rst time
you use the processor.
• Place the processor on a level surface.
• Place the XXL bowl over the shaft of the motor base, making sure
the handle is properly positioned to the left of centre. Turn the
bowl to the right until it is locked onto the housing base.
• To use the XL bowl, place your thumbs in the nger recesses to
slot it into the XXL bowl, the spout should be turned to the back
of the unit. The two nooks should slot in the grooves of the XXL
bowl.
• To use the rapid preparation work bowl, place your thumbs in
the nger recesses to slot it into the XL bowl with the spout
turned to the back of the unit. The two nooks should slot into
the grooves of the XL bowl.
Note: To use the XL bowl, it should be inserted in the XXL bowl. To
use the rapid preparation work bowl, it must be inserted into the
XL bowl which should in turn be placed in the XXL bowl.
B. Removing the bowls from the processor
• To remove the XL bowl and the rapid preparation bowl, use the
nger recesses located on each side of the bowl and pull up.
• To remove the XXL bowl, grasp the housing base rmly with your
left hand, hold the handle of the bowl in your right hand and
turn clockwise to unlock the bowl assembly.
Note: The bowls lock into each other automatically and will
remain locked when pouring out preparations.