23
01040692 B 04/21
Culligan
Aquasential Select Series 9" S Water Softener
Culligan knows the more informed you are about your water treatment systems, the more confident you will be about its performance� It’s because
of this and more than seventy years of commitment to customer satisfaction that Culligan is providing this Performance Data Sheet to its customers�
NOTE! Read this Performance Data Sheet and compare the capabilities of this unit with your actual water treatment needs.
It is recommended that before purchasing a water treatment unit, you have your water supply tested to determine
your actual water treatment needs.
Manufacturer: Culligan International Company
9399 W� Higgins Rd�, Suite 1100
Rosemont, IL 60018 USA
(847) 430-2800
www�culligan�com
Product: Culligan
Aquasential Select Series 9" S Water Softener
Testing Conditions & Results:
Flow Rate: 7�6 gpm @ 15 psi Capacity: 4,329 grains @ 3�0 lb salt
Pressure: 30 - 40 psi 5,484 grains @ 5�0 lb salt
Acidity: Non-Corrosive 6,563 grains @ 7�0 lb salt
Softener Specifications:
Service Flow Rate: 7�6 gpm (28�8 Lpm) Pressure Drop at Max� Flow Rate: 15 psi (103 kPa)
Working Press� Range: 20 - 125 psi (140 - 860 kPa) Oper� Press� Range (Canada): 20 - 90 psi (140 - 620 kPa)
Substance Reduction
While testing was performed under standard laboratory conditions, actual performance may vary�
Name of Substance USEPA Max. Contaminant Level pH Flow Rate Pressure
Barium 2�0 mg/L 7�5 ± 0�5 7�6 gpm 15 (psig)
Radium 226/228 5 pCi/L 7�5 ± 0�5 7�6 gpm 15 (psig)
This system is certified for barium and radium 226/228 reduction based on hardness reduction� It is recommended you
test your water every 6 months to ensure the system is performing properly and that hardness, and therefore barium
and radium 226/228, are being reduced�
The Culligan Aquasential Select Series 9" S Water Softener has been tested and certified by WQA against NSF/ANSI
372, CSA B483�1, and NSF/ANSI Standard 44 for the effective reduction of hardness (calcium and magnesium),
barium, and radium 226/228, as verified and substantiated by test data� To maintain product certification and ensure
uniform performance, the product is retested on a consistent basis�
Refer to the Specifications, Familiarization and Warranty section of this Owner’s Guide (P/N 01040692) for more
specific product information� To avoid contamination from improper handling and installation, your system should
only be installed and serviced by your Culligan dealer� Performance will vary based on local water conditions� The
substances reduced by this system are not necessarily in your water�
Culligan water softeners are designed to work with any salt of good quality, although it is recommended that you ask your
local Culligan dealer for his suggestion on the best type and grade of salt to use in this softener�
NOTE! This softener is not intended to be used for treating water that is microbiologically
unsafe or of unknown quality without adequate disinfection before or after the system.
To Next Page
Loading...
