d)
b)
30cm
20cm
20cm
20cm
20cm
The placement of the coffee grinder is
a decisive factor, both for the perfect
perfomance of the machine and for the user’s
health. Its placement in an inadequate site
for use can result in adverse physiological
effects, for instance, uncomfortable posture
or unnecessary excess effort.
For this reason, please bear in mind the
following precautions before deciding a site
for the coffee grinder:
a)Place it on a flat, stable surface, at a height
which allows easy and safe operation.
b)Place it at an appropiate distance from
a grounded mains outlet which will allow
you to effortlessly plug it in and unplug it
(approx. 110 cm.).
Never pull the power cord to unplug the
grinder; always grip the
plug.
c)Keep the following
minimum clearances to
ensure perfect operation of
the coffee grinder, as well as for easy and
safe use and cleaning:
WIDTH: There should be a minimum
clearance of 20 cm. on both sides of the
coffee grinder.
DEPTH: There should be a minimum
clearance of 20 cm. in front of and behind
the coffee grinder.
HEIGHT: There should be a minimum
clearance of 30 cm. on top of the coffee
grinder.
d).-For your convenience, place the coffee
grinder near the coffee espresso machine.
This will avoid unnecessary trips back &
forth.
11
Placement of Coffee Grinder
e)Do not place the coffee grinder near
running water or places where foreign
objects can penetrate the interior of the
machine.
f)Do not leave the coffee grinder near
heat sources like radiators or air ducts, or
where it can be subjected to direct sunlight,
excess dust, rain, mechanical vibrations, or
impacts.
g)To avoid internal overheating, place the
coffee grinder in a properly ventilated area.
The electrical installation of your coffee
grinder should be left to qualified personnel,
always adhering to the following safety
indications:
a).Make sure the electrical data on the coffee
grinder’s Specifications Plate (see section 37
of this manual) match your mains power.
b)The coffee grinder must be connected
to a grounded mains
outlet meeting your
country’s regulations.
Non-fulfilment of
this requirement may
constitute a serious
hazard to your
health. The manufacturer
may not be held liable for any
injuries or harm caused by a non-grounded
mains power outlet.
c)The power source must be protected by
means of a magneto-thermal switch suited
to the power required by the coffee grinder,
as indicated on the grinder’s Specifications
Plate (see section 37 of this manual).
d)There should be a differential relay suited
to the characteristics of the mains wiring.
e)Make sure the mains wiring is suited to the
device’s power consumption.
f)Do not use cable extensions, adaptors or
multiple-switch boards or plugs to connect
the coffee grinder to the mains outlet.
12
Electrical Wiring
Before using the coffee grinder for the first
time, follow the instructions below to load
coffee beans:
a) Make sure the coffee bean hopper (2)
is correctly placed and attached by the
lockscrew (3) to the grinder adjustment
platen (4).
b) Close the trap
(5) preventing
the beans
from entering
the grinder
chamber.
c)Lift the hopper lid (1), fill the hopper with
coffee beans (2) and close the lid.
d)Slide the trap
(5) to its outer
position letting
the beans drop
into the grinder
chamber.
The manufacturer may not be held liable for
injuries or harm to persons and/or animals,
or material damages resulting from the
incorrect installation of the coffee grinder
or failure to comply with any of the above
indications.
13
Before Using the Coffee Grinder
To Previous Page
Loading...
