Mod. SALSA
H: 560mm L: 290mm W: 180mm Wei: 25Kg
Nº motor: 1+1 ventilator
Voltage: 230v -110v -Frequency: 50Hz-60Hz
Phases: 1(mono) - Amperage4,4A - 9,2A
Power: 0,60/920
Condenser: 25nf-450v - 100nf-400v
Speed: 1300-1650-G/P: IP21.
Maximum Continuous Service Time:30min.
Motor equipped with Thermal Protector
Tempered Steel Grinding Wheels, 60mm
Duration of Grinding Wheels:500kg Cof.B.
Hopper Capacity: 1 Kg.
Dispenser adjustment
: 5Gr-12Gr.
Dosif.: Elektronic
Minimum Time in Repose: 10 min.
UGANDA - “Silencer” Model
H:520mm L:355mm W:210mm Wei:13Kg
Number of motors: 1
Voltage:230v-110v-Frequency:50Hz-60Hz
Phases:1(single)-Amperage:1,55A-3,41A
Power:0,16/325
Condenser: 10nf-450v - 40nf-400v
Speed:1300-1650 Protection degree:IP21
Maximum Continuous Service Time:30min.
Motor equipped with Thermal Protector
Tempered Steel Grinding Wheels, 60mm
Duration of Grinding Wheels:500kg Cof.B.
Hopper Capacity: 1 Kg.
Dispenser Capacity: 300 Gr.
Dispenser adjustment: 5Gr - 12Gr.
Optional: Automatic On/Off function.
Minimum Time in Repose: 10 min.
07
Technical Specifications
07
Technical Specifications
22
Cleaning the Grinding Teeth
23
Cleaning the Feeder
Frequency: Every 25 days.
Use a round brush with semi-rigid bristles.
The brush should be long enough to reach
all parts. Try to use a brush exclusively for
cleaning the coffee grinder and store it in a
clean, dry space.
a) Unplug the grinder.
b) Loosen the lockscrews
(3) and remove the
hopper (2).
c) Press the adjustment
trigger (6) and keep
it pressed to free the
adjustment platen (4)
and turn the platen
TOWARDS THE LEFT, in
the direction of the “G”
arrow, until you remove
the platen.
d) Clean the grinding
teeth and all other
elements in the housing
using the brush,
completely dry and
without using any type
of liquid.
e)Replace the
adjustment platen (4)
and turn it TOWARDS
THE RIGHT, in the direction of the “F”
arrow, until reaching the grinding position
you want. (See section 17 for coffee grinding
thickness adjustment).
Frequency: Every 25 days.
Use the same brush for cleaning the grinding
teeth.
a) Unplug the grinder.
b) Move the feeder handle (15) back and
forth as many times as needed to empty the
feeder (8).
c) Remove the
feeder lid (7).
d) Use the brush,
completely dry
and without
using any type of
liquid, to clean
the inner surface
of the feeder (8)
Move the feeder
handle (15) back
and forth to clean
thoroughly.
e) Replace the
feeder lid (7).
If the outside of the coffee grinder becomes
dirty, clean it with a soft cloth dampened
in water. Remember to turn off the grinder
using the On/Off switch (11) and unplug it
before cleaning.
Cleaning of the interior of the
interior of the coffee grinder
should be perfomed ONLY
BY CUNILL TECHNICAL
SERVICE STAFF.
24
Cleaning the outer Body of the
Coffe Grinder
To Next Page
Loading...
