DKC600 (U) & DKC600 (U)Y SLIDING GATE OPERATOR USER’S MANUAL
1. Important Safety Information
Carefully read and follow all safety precaution and warnings before attempting to install and use
this operator, incorrect installation can lead to severe injury.
The gate operator should be installed by a qualified technician; otherwise, serious
personal injury or property damage may occur.
When opening or closing the gate, do not attempt to walk or drive through the gate.
Children should not be allowed to play near or operate automatic gates.
The automatic gate operator must be grounded.
Install the gate operator on the inside of the property, DO NOT install it on the outside of
the property where the public has access to it.
Be careful when in close proximity to moving parts where hands or fingers could be
pinched.
Do not allow control devices to be placed so that a person can access them by reaching
through the gate.
In the event of power failure, an emergency release key allows you to operate the gate
manually.
The operator should be switched off before repairing it or opening its cover.
Please erase and reprogram the code after installing the operator.
Additional safety equipment such as photoelectric sensors, alarm lamp must be
installed to prevent injury.
Any changing of the opening & closing speed is not allowed. If you have any special
requirements, please kindly contact a dealer.
Our company reserves the right to change the design and specification without prior
notification.
2. Main Technical Parameters
Tab.1
14m/min (24 teeth)
12m/min (19 teeth)
17 m/min (24 teeth)
13m/min (19 teeth)
14m/min (24 teeth)
11m/min (19 teeth)
17 m/min (24 teeth)
13m/min (19 teeth)
All-in-one gate operator, control board included
Magnetic limit switch or spring limit switch（according to your order）
Remote control
operating range
To Next Page
Loading...
