Cupra BORN - Page 158

Assistant systemsDrive assist sensors and cameras
157
NOTICE
To avoid aecting the operation of the sys-
tems, take the following points into consider-
ation:
•
Clean the eld of vision of the camera reg-
ularly and make sure it is free of snow and ice.
•
Do not cover the eld of vision of the cam-
era.
•
Check that the windscreen is not damaged
in the area of the camera's eld of vision.
Rear radar
Fig. 124 Rear view of the vehicle: radar
sensor areas.
Fig. 125 Sensor detection zones.
The radar sensors are located on the left and
right of the bumper and are not visible from
the outside
›››
Fig. 124. The sensors monitor
both the blind spot and traic behind the vehi-
cle ››› Fig. 125.
They support the following functions:
•
Lane departure warning (Side Assist)
››› page 182.
•
Rear cross traic alert (RCTA)
›››
page 185.
•
Door opening warning (Exit Assist)
››› page 186.
Automatic deactivation of supported func-
tions
The rear radar sensors deactivate automati-
cally when, among other reasons, one of the
sensors is detected to be permanently cov-
ered. This may be the case if, for example,
there is a layer of snow or ice over one of the
sensors.
The relevant text message will appear in the
instrument panel display.
NOTICE
• The radar sensors on the rear bumper may
be damaged or shifted in the event of a colli-
sion, for example, when entering or exiting a
parking space. This may result in the system
disconnecting itself, or at least possibly hav-
ing its functionality diminished.
•
In order to ensure that the radar sensors
work properly, keep the rear bumper free of
snow and ice and do not cover it.
•
The rear bumper should only be painted
with paint authorised by CUPRA. The lane
departure warning's functions may be limited
or work incorrectly if other paints are used.
•
The visibility of radar sensors may be aec-
ted due to leaves, snow, strong haze or dirt,
among others. Clean the area in front of the
sensors.
•
Never use auto lane changing or the rear
cross traic alert if the radar sensors are
dirty.
Ultrasound sensors
The bumpers are tted with ultrasound sen-
sors to perform the following functions:
•
Park assist plus
›››
page 193.