Cupra Formentor PHEV - Operating the Speed Limiter with the Multifunction Steering Wheel

Assistant systems
Operating the speed limiter with the
multifunction steering wheel
Fig. 152
On the multifunction steering wheel:
buttons to operate the speed limiter.
Connecting
●
Press the  butt
on.
It does not t
ake effect yet.
Start regulation
●
When the vehicle is moving, press the but-
ton .
The current speed is saved as a limit speed.
Adjusting the speed
The programmed speed can be set:
+ 1 km/h (1 mph)
- 1 km/h (1 mph)
+ 10 km/h (5 mph)



- 10 km/h (5 mph)
Interrupting the adjustment
●
Press the  button.
The speed is stored.
Reinstating the cruise control
●
Press the  button.
The limiter will re-activate as soon as the ve-
hicle is moving at a speed lower than the
saved one.
Switching off
●
Press and hold the button .
The speed limiter switches off and the speed
is deleted.
Switch to cruise control (GRA) or adaptive
cruise control (ACC)
●
Press the  button.
●
Observe the corresponding message on
the instrument cluster display.
The speed limiter is switched off.
Note
Depending on the equipment, the speed
limiter can be found on the multifunction
steering wheel or on the turn signal lever.

Problems and solutions
The speed limiter is not active.
The control lamp s
witches on yellow.
●
Malfunctions Switch off the speed limiter
and go t
o a specialist workshop.
The adjustment is interrupted unexpect-
edly
●
You have switched off the Electronic Stabi-
lization Control (ESC).
●
The brakes have overheated. Wait for the
brak
es to cool down and check the opera-
tion again.
●
If the fault continues, consult a specialised
workshop.
For safety reasons, the speed limiter only
switches off fully whenever the driver stops
pressing the accelerator pedal or switches
the system off manually.
Not possible to start regulation
●
The selected driving profile does not allow
regulation to start. Select another profile and
repeat the procedure.
 
237