Cupra Formentor PHEV - Opening and Closing; Set of Vehicle Keys

Opening and closing
Opening and closing
Set of vehicle keys
Vehicle key
Fig. 69
Vehicle key
Fig. 70 Centre console: vehicle key socket.
Key to
›
›
›
Fig. 69
Unlock the vehicle
1
Lock the vehicle
Unlock only the r
e
ar lid. Press the button
until all the turn signals on the vehicle
flash briefly. You have 2 minutes to open
the rear lid. Once this time has passed, it
will lock again. In addition, the lamp on
the key flashes.
Control lamp
Alarm button*. Only press in the event of
an emergency! When the alarm button is
pressed, the vehicle's sounds and the
turn signals light up for a short time.
Press again to disconnect.
With the vehicle key the vehicle may be
locked or unlocked remotely
›››
page 94 .
The vehicle key includes an emitter and bat-
tery. The receiver is in the interior of the ve-
hicle. The range of the vehicle key with re-
mote control and new battery is several me-
tres around the vehicle.
If it is not possible to open or close the vehi-
cle using the remote control key, this should
be re-synchronised
›››
page 93 or the bat-
tery changed
›››
page 93 .
Different keys belonging to the vehicle may
be used.
Control lamp on the vehicle key
When a button on the vehicle key is briefly
pressed, the indicator lamp flashes
4
›››
Fig. 69 once briefly, but if the butt
on is
2
3
4
5
held down for a longer period it will flash sev-
er
al times, such as f
or convenience opening.
If the vehicle key control lamp does not light
up when the button is pressed, replace the
key's battery
›››
page 93 .
Key socket
There is a key socket near the start button
›››
Fig. 70 . Warning! Do not confuse with
the location for the emergency start
›››
page 209.
Spare key
To obtain a spare key and other vehicle keys,
the vehicle chassis number is required.
Each new key contains a microchip which
must be coded with the data from the vehi-
cle electronic immobiliser. A vehicle key will
not work if it does not contain a microchip or
the microchip has not been encoded. This is
also true for keys which are specially cut for
the vehicle.
The vehicle keys or new spare keys can be
obtained from a specialised CUPRA dealer or
SEAT Official Service, a specialised workshop
or an approved key service qualified to cre-
ate this kind of key.
New keys or spare keys must be synchronised
before use
›››
page 93 .
»
91