Cure It GRP - Product Components; Component Parts Overview

6
This diagram shows a breakdown of a typical
CureItroonginstallationanditscomponentparts:
1
10
3
4
5
6
7
8
9
11
2
General information
Component Parts of Cure It Roof
1 B260 Raised edge trim
2 D260 Fillet trim
3 C100Simulatedleadashing
4 A200 Drip edge trim
5 C1 universal external corner
6 2400mmX600mmX18mmOSB3TongueandGroovedecking
7 CureItlaminatecomprisingofroongresinandroongmat
8 CureItRoongTopcoat
9 AT 195 External Angle Trim
10 D260 Fillet Trim
11 F300 Flat Flashing
1 C100Simulatedleadashing.
2 The edge of this roof was masked off before the aggregate
 nishwasapplied.
3 C1 preformed universal external corner.
4 C4 Preformed universal internal corner.
5 A200 drip trim - Laid to facilitate water running off the roof.
6 A slight fall is engineered into the substrate to avoid
standing water.
7 B260 Raised edge trim.
8 D260 - laminated into the substrate, remains unattached
 behindtheC100ashing.
MostCureItroonginstallationsareforsimpledomesticatroofsliketheoneshownbelow.Roofsliketheseincorporatethefourmost
commonlyusedtrims:A200,B260,C100&D260.Theroofshownbelowhasbeennishedinapigmentedgreentopcoatwithanexposed
aggregatenish.
2
4
5
6
8
3
7
1