GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
1-800-798-0813
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
32
20
VOLVO C70
10/19/2012
11065
40
Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX BOLTM8-1.25 x 3541
CONICAL TOOTHED WASHER3/8"
42
CARRIAGE BOLT1/2-13 x 1 1/2
23
.250 x 1.00 x 2.00" SQUARE HOLE SPACERCM-SP1224
HEX FLANGE NUTHFN 121325
TOOLS REQUIRED
RATCHET
10mm & 3/4" SOCKETS
TORQUE WRENCH
1. Lower exhaust by removing (2) M8 fasteners from each exhaust hanger bracket. Return (4) M8 fasteners to
vehicle owner.
2. Raise hitch into position and loosely attach it to vehicle tie down brackets using the supplied 1/2" hardware
and SP12 spacers, as shown above. (NOTE: Hitch will be sandwiched between frame and exhaust hanger
brackets)
3. Secure exhaust hanger brackets and hitch to frame using the supplied M8 fasteners and 3/8" conical tooth
washers.
4. Torque all M8 fasteners to 24 ft-lbs and all 1/2" hardware to 110 ft-lbs.
EURO MOUNT OPTION AVAILABLE
#45591 (1 7/8" BALL) AND #45592 (2"BALL)
DESIGNED FOR
USE WITH
BALLMOUNT #45522
-NO DRILLING REQUIRED
-LOWER EXHAUST
VEHICLE TIE
DOWN BRACKET
(BOTH SIDES)
EXHAUST HANGER BRACKET (BOTH SIDES)
PASSENGER SIDE FRAME RAIL
DRIVER SIDE FRAME RAIL
EXISTING WELDNUTS (BOTH SIDES)
4
3
5
2
1
To Previous Page