Curtis 3301T - Viewing and Editing Parameters; Fault Monitoring

2 — USING THE 3301T
pg. 9
Return to TOC Curtis Model 3301T Digital Instrumentation – September 2021
VIEW FAULT NAMES
e Fault Name screen displays the names and fault codes of active faults. In the following example,
faults are active for traction and pump controllers:
Take the following steps to access the Fault Name screen:
1. Go to the home screen.
2. Press the
+
+
button.
3. If there are too many faults to display on one screen, the bottom of the Fault Name screen will
display upward-facing and downward-facing triangles. Use the
H
and buttons to scroll
through the screens.
To exit the home screen, press the
+
+
button.
VIEW AND EDIT PARAMETERS
You can use the 3301T to view and edit parameters for the 3301T and for other Curtis devices
connected through the CANbus or the serial port. e 3301T parameters are contained by the menus
described in the Programmable Parameters and Monitor Parameters chapters. e parameter menus
can be accessed when the home screen is visible.
Parameters have two access levels: User and OEM. e OEM level provides access to more parameters
than the User level. e following table describes how the 3301T access levels correspond to the
access levels for Curtis programming devices:
Table 1 3301T and Curtis Programming Device Access Levels
3301T Curtis Programming Device
User Field Intermediate
OEM OEM Dealer
A password is required to access the 3301T’s parameter menus and the read-write parameter menus
of other Curtis devices. e access levels have dierent passwords. When you enter a password, the
password is not cleared when the device returns to the home screen; this is for convenience when
testing and debugging parameter changes. Aer you have nished working with parameters, cycle
the keyswitch to clear the password.