3 — INSTALLATION AND WIRING
Curtis Model 3301T Digital Instrumentation – September 2021
Return to TOC
pg. 22
3 — INSTALLATION AND WIRING
is chapter explains how to install and wire the 3301T.
INSTALLING THE 3301T
Install the 3301T in a location that will keep the device clean and dry. e recommended panel cutout
is 74.3 + 0.8/–0 × 125.3 + 0.8/–0 mm, with a panel thickness between 2.0–4.0 mm.
Figure 6
Mounting
Dimensions
125 ±0.3
74 ±0.3
36.5 ±1
4.2 ±0.3
47.2 ±1
80 ±1
136 ±1
4X R8
4X R5.5
To Next Page
Loading...