Curtis 700 series Manual

18 19
5. TROUBLESHOOTING
To maximize the life of this meter, please read
all instructions carefully and review Safety
Precautions on inside front cover of this manual. Most
minor problems can be resolved by removing all power
for at least 10 seconds and then reconnecting.
Problem Possible Cause
No Display Power not connected or too low.
Display Present, but counter
does not activate.
Input (or enable) wire not connected. Start
Input not connected. Input voltage not reaching
specified minimum signal level.
LED not turning ON during
activation condition.
Switch or switch-connection faulty.
6. MAINTENANCE
Curtis Model 700 & 732 Series hour meters are not
serviceable in the field. Units returned to the factory within
the warranty period (see inside backcover) will be replaced
without charge.
7. WARRANTY
Curtis Instruments’ products and/or components are
guaranteed against defects in workmanship and material
for a period of two years, or as defined in the individual
product literature, from date of shipment from our factory,
when applied in a proper application within specified ratings.
This guarantee is limited to repairor replacement F.O.B. our
factory. There is no further warranty or implied representation,
guarantee, promise or agreement as to any Curtis Instruments
product and/or component. Curtis Instruments, Inc., cannot
assume responsibility or accept invoices for unauthorized
repairs to its products and/or components,even though
defective. In no case will Curtis Instruments’ responsibility
extend to products, components or equipment not of its
manufacture. Under no circumstances shall Curtis Instruments,
Inc., be liable for any special or consequential damages or
loss of profits or other damages. Returned goods will not
be accepted unless identified by a Curtis Return Material
Authorization (RMA).
All specifications are subject to
change without notice.

Curtis 700 series Specifications

General

Brand	Curtis
Model	700 series
Category	Measuring Instruments
Language	English