Curtis CAFE PC1 - Programming Procedures; Programming Overview and Modes; Product Ratio and Liquid Dispense Settings

Steps to Programming
2
Your Curtis Cafe System is Factory Pre-Set for Optimum Performance. Usually this Does Not Change.
Numberof
Flashes
10%
20%
30%
40%
100%
1
2
3
4
10
Volume
Manual Liquid Dispensing Mode
ThisfeaturesetsuptheCaféPCunittodispenseproductonlyaslongastheuserholdsdowntheselectedPUSHbutton.
Assoonastheuserstopspressingthebutton,productstopsowingintothecup.SettingtheunitforManualLiquidDispensewillturnoffthe
PortionControlDispenseMode.
Enter Program Mode – pressandholdSTOP/WASHforaboutten[10]secondsuntilalllights
startblinking.
To program Product % Ratio,pressandholdtheselectedPUSHbuttonforapproximately
onesecond,thenrelease.ThecurrentsettingwillbeindicatedbyLEDashes.
To change the product throw,pressandholdthebuttonuntillightstartsquickashing.Eachquickashincreases
theamountby10%.Releasethebuttonwhenthedesiredthrowamountisachieved.Afterreleasingthebutton,the
numberofblinksrepresentthenewsetting.
To exit the Powder Dispensing Mode,pushanyotherPUSHbutton.
Product % Ratio
Thiscontrolstheamountofdryproductthatismeteredfromthehoppers.Thiscanbeprogrammedfrom10%to100%ofthecapacityofthe
dispensingsystem.BycountingLEDashesyoucandeterminetheproduct%ratiocurrentlysetforthisdispensebutton(seetable).
Portion Control Liquid Dispensing Mode
Thisprogramadjustmentallowsyoutosetupthemachinetoautomaticallydispenseapresetvolumeofcappucinoproduct.Whentheuser
makesaPUSHbuttonselection,theunitdispensesonlythevolumeofcappucinoproductprogrammedbythePortionControlDispensing
Mode.BysettingtheunitforPortionControlDispensing,youhavelockedoutthemanualdispensefeature.
Enter Program Mode – pressandholdSTOP/WASHforaboutten[10]secondsuntilalllightsstartblinking.
To select & change the Portion Control Dispensing Volume–whileintheprogrammingmode,pressandholdthe
selectedPUSHbuttonuntiltheliquidbeginstoow,thenrelease.Thetimingstartswhenliquidbeginstoow.
Stop ow and Exit – Whenthedesiredvolumeisachieved,pressthisPUSHbuttononceagaintostopthedispens-
ing.
Youhavenowsetthetimingforthisbuttonandhaveexitedtheprogrammingmode.Pressingtheselecteddispense
buttonnowwillprovidetheliquidvolumethatyoujustset.Toresetthetiming,youmuststartagainbyenteringthe
programmingmode.
WARNING HOT LIQUID, Scalding
mayoccur.Avoidsplashing.
Placeanemptycontainerunderthe
dispensing nozzles while programming.
Allprogrammingisperformedatthecontrolpanel
(illustration,right).
TheSTOP/WASH BUTTONhasseveralfunc-
tions.ThisbuttonisusedtostopaPortionControl
dispensecycle.Itisusedtowashoutthemixinganddispensingsystemsanditisusedtoenterprogrammingfunctions.