Curtis D1000GT - Quick Start Guide; To Go Into Programming; Program Menus; Brew By Volume

Program Menus
FromProgramMenuspress>displaywillnowshowthenextfeature.
SelectingBrewbyVolumeorBrewbyTimedependsonwhetheryouknowyourbrewtimebeforestarting.
Brew by Volume (Factory set to 74 oz)
Press toSelect,displaywillnowshowSelectButton.SelectdesiredBrewbutton.ToBegin...PresstheBREWbuttonthen
hotwaterstartsrunning,whencorrectvolumeisreachedpressBREWbuttonagaintostoptheow.Nowthevolumehasbeen
set.Pressing>buttonwilldisplaythesubsequentmenufeatures.
Brew by Time (Factory set to 3 min – 0 sec)
Press toSelect,displaywillnowshowSelectButton.Thecurrenttimeisnowshown.Bypressing<>youcantoggleback
andforthfromminutestosecondstoexit(ex).Changethetimeorsetandexitbypressing.
Temperature (Factory set to 200°F)
Press toSelect.Press<>tomovetodesiredtemperatureandthentoset.Temperatureisprogrammablefrom170ºFto
206ºFin2-degreeincrements.
Energy Save Mode (Factory set to OFF)
Press toSelect.Press<>toselectONorOFF,toset.WheninON,unitwillautomaticallyshutoff4hoursfromlast
brew.WhenfeatureisOFF,unitdoesnothavetheenergysavingmode.IntheON140ºFposition,temperaturegoesdownto
140ºFifunithasnotbrewedin4hours.Thisfeaturewillsaveenergybynotheatingthetankduringperiodsofnon-operation.
Brew Count Odom.
Press todisplaytotalgallonsbrewed.PressexorReset
Pre-Infusion (Factory set to OFF)
Press toSelect.DisplaywillnowshowSelectButton.SelectdesiredBrewbutton.Currentsettinginsecondsisdisplayed<
todecreaseorselect>toincrease(rangefromOFFto10through60seconds), to set.
IfPre-infusionisselected(ON),ColdBrewLockissettoDelta1within5ºFofsetpointandColdBrewLockandPulseBrew
disappears from the list of program selections.
ToGoIntoProgramming
Turnoff(darkdisplay)bypressingON/OFFbutton(yellow).PressandholdBREWbutton(green)andthenpressandreleaseON/OFFbutton.
ContinueholdingBREWbutton.Displaywillread ,waituntil  isdisplayedEnterthe4-digitaccesscode,thedigits1-4correspond
to the buttons (see illustration below).
Thedefaultcodesetatthefactoryis1-2-3-4.Then willbedisplayed.
ENTER CODE
– – – –
PROGRAM MENUS
< SELECT >
ENTERING PROGRAM
MODE
All programming selections are performed with the three center buttons.
The symbols below the buttons are:
ScrollLEFT
 SELECTIONorENTERtosavenewparameter
  ScrollRIGHT
Temperature
BrewByTime
BrewByVolume
Program Menus
EnergySaveMode
BrewCountOdom
Continued, Page 3
PROGRAM MENUS
EachbrewbuttonvolumeisindependentlyprogrammableforBrewVolume(volumeortime),Pre-infusion,and
PulseBrew.Duringactualbrewcyclea2-minutedripmodeisaddedtothebrewtime.
Pre-Infusion
2