Brew Volume (Factory set to 2.2 Liters)
Selecting Brew by Volume or Brew by Time depends on whether you know your brew time before starting.
From Program Menus press > display will now show the next feature.
to Select, display will now show Select Button. Select desired Brew button. To Begin... Press the
BREW button then hot water starts running, when correct volume is reached press BREW button again to stop the flow. Now
the volume has been set. Pressing > button will display the subsequent menu features.
Next item in the sequence is Brew by Time. Press
to Select, display will now show Select Button. The current time is now
shown. By pressing < > you can toggle back and forth from minutes to seconds to exit (ex). Change the time or set and exit
Temperature (Factory set to 200°F)
to Select. Press < > to move to desired temperature and then
to set. Temperature is programmable from 170ºF
to 204ºF in 2-degree increments.
Energy Save Mode (Factory set to OFF)
to Select, < , >, ON, OFF or ON 140ºF ,
to set. When in ON, unit will automatically shut off 4 hours from last
brew. When feature is OFF, unit does not have the energy saving mode.
In the ON 140ºF position, temperature goes down to 140ºF. if unit has not brewed in 4 hours. This feature will save energy by
not heating the tank during periods of non-operation.
to display total brew cycles. Press ex or Reset
Turn off (dark display) by pressing ON/OFF button (yellow). Press and
BREW button (green) and then press and release ON/OFF button.
hold BREW button (green) and then press and release ON/OFF button. hold
Continue holding BREW button. Display will read , wait until is displayed Enter the 4-digit access code, the digits 1-4 cor-
respond to the buttons (see illustration below).
The default code set at the factory is 1-2-3-4. Then will be displayed.
On D1000GT ONLY, brew buttons are independently programmable for Brew Volume (Volume or Time), Pre-infusion or Pulse
Once volume is set and during actual brew cycle a 2 minute drip mode is added to total brew time.
All programming selections are performed with the three center buttons.
The symbols below the buttons are:
SELECTION or ENTER to save new parameter
Model Select - D500GT ONLY. Always perform this fi rst. This feature re-sets all settings to the factory defaults.
Scroll through menu to Model Select. Choices are: ALPHA-1, ALPHA-2, ALPHA-3/4/5, Airpot Brewer and Thermo-Alpha.
Select only Airpot Brewer.
To Next Page
Loading...
