OPERATING INSTRUCTIONS OI2
Brewing Instructions
The G4 Combo Brewer is factory preset for optimal performance.
($#)4($#)501&3"5*/(*/4536$5*0/4ø "
2 Remove the lid from
an empty coffee or tea
dispenser and position it
on the brew deck. Center it
under the brew basket.
3 Select the brew basket
labeled for the type of
beverage being brewed (hot
coffee, iced coffee or iced tea)
BOEJOTFSUBDMFBOQBQFSmMUFS
Fill with the proper amount of
coffee or leaf tea. Level the
DPGGFFUFBJOUIFmMUFS
4 4MJEFUIFmMMFECSFXCBTLFU
into the brew rails under the
control panel. Slide it all the
way back until it stops.
)PMEZPVSmOHFSPOUIF
appropriate brew icon. As
soon as you hear the click
of the brew valve, lift your
mOHFS#SFXJOHXJMMCFHJO
The brewer will brew coffee or tea based on the settings programmed into the universal control module (UCM). To
change the settings, see the PROGRAMMING GUIDE.
The brewer should be ON.
$POmSNUIJTBUUIFSFBSUPHHMF
switch. “Ready to brew”
should be on the display.
WARNING - TO AVOID SCALDING, AVOID SPLASHING. Keep body parts clear of the brewer during
brewing. Do not remove the brew basket while “Brewing” appears on the display.
WARNING - DO NOT refrigerate unused tea overnight for later consumption.
6 If a keypad appears on
the display, the brew code
feature is enabled (default
is off). Brewing will start
immediately after you enter
the brew code. See the
PROGRAMMING GUIDE to
set up/disable the brew code.
To Next Page
Loading...
Need help?
General
