Curtis G4 Series User Manual

CLEANING INSTRUCTIONS CI6
5&"%*41&/4&3$-&"/*/(*/4536$5*0/4ø "
Cleaning the Tea Dispenser (Daily)
Cleaning the Container
 Prepare a mild solution of detergent and warm water.
Remove the dispenser from the brewer and remove the
lid. Rinse.
2 Wash - Wipe the exterior surfaces with a sponge and
the detergent solution to remove spills and debris. Use
the detergent solution and a soft bristled brush to wash
the inside of the container.
3 Rinse - Rinse with clean, warm water.
4 Sanitize* - Sanitize the interior of the dispenser using a
commercial sanitizer suitable for food grade applications.
Sanitize according to the directions on the package.
* If a three compartment sink large enough to submerge
the dispenser is not available, swab, brush or pressure
spray the sanitizing solution according to the directions
on the package.
5 Air Dry - Turn the container upside down and allow to
air dry.
Cleaning the Faucet Parts, Lid and Drip Tray
 Disassemble the faucet - Unscrew the faucet assembly
from the dispenser. Then, unscrew the handle/bonnet
assembly from the top of the faucet and remove. Inspect
the seat cup for wear. Replace the seat cup if it is
damaged.
2 Wash - Wash the lid, drip tray and faucet parts with the
detergent solution.
3 Rinse - Thoroughly rinse all parts with clean, warm
water.
4 Sanitize - After rinsing, place the faucet parts in the sink
to be sanitized. Immerse them in a commercial sanitizer
suitable for food grade applications. Sanitize according
to the directions on the package.
5 Air Dry - Allow all parts to thoroughly air dry.
6 Reassemble - When dry, reassemble the handle/bonnet.
Hand tighten the handle/bonnet onto the top of the faucet
assembly. Hand-tighten the faucet assembly onto the
dispenser outlet.
Seat cup
Faucet
Handle
Bonnet

Curtis G4 Series Specifications

General

Brand	Curtis
Model	G4 Series
Category	Brewing Systems
Language	English