EasyManua.ls Logo

Curtis RU Series - Installation Procedures; Site Preparation and Leveling; Component Installation

Curtis RU Series
43 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3 Position the urn on the countertop. Level it left to right
and front to back by turning the feet at the bottom of
the legs.
Installation
Prepare the Location
1 Determine the location. Make sure that the counter is
capable of supporting at least 600 lbs. to allow for the
urn weight at full capacity.
INSTALLATION INSTRUCTIONS II7
WARNING: Use the leveling legs to level the urn
only. Do not use them to adjust the urn height.
Do not extend them higher than necessary.
WARNING: DO NOT place the urn closer than
6 inches from the wall. The urn must have
adequate cross-ventilation.
Level the Unit
2 Remove the urn from the shipping carton and install
UIFMFHTPOUIFDPSOFST4DSFXUIFNmSNMZJOUPQMBDF
on the bottom of the unit.
36"650."5*$*/45"--"5*0/*/4536$5*0/4ø "
Install the Faucets
4 Install the faucets on the front of the unit. Be careful
not to over tighten the faucet mounting nuts.

Other manuals for Curtis RU Series

Related product manuals