OPERATION
21
OPERATION
SAFETY
Failure to operate the vehicle correctly can result in a collision, loss of control, accident
or rollover, and cause serious injury or death. Follow all operation procedures in this
section of the manual. Read and comply with all safety warnings in the safety section of
this owner’s manual.
BEFORE INITIAL USE
To prepare your new vehicle for operation, complete the following:
• Remove the protective plastic from the seats.
• Check for possible leaks that may have developed during shipment of the vehicle.
• Charge the battery.
• Fill tank with correct fuel.
• Perform the following pre-ride inspection.
PRE-RIDE INSPECTION
Inspect and verify that the vehicle is in safe operating condition before each use to decrease the risk of an accident.
Check the items in the table to help ensure safe and reliable operation.
ENGINE BREAK-IN
Correct operation of the engine during the break-in period is essential to the performance, reliability and life of the
engine.
The engine break-in period is:
• the first 100 operating hours of a new engine
• the first 100 operating hours of an engine that has been completely disassembled
• the first few minutes until the engine is warm at each operation
During these break-in periods, operate the vehicle in the following manner:
• Avoid high engine speeds.
• Avoid long periods of idle time.
• Avoid long operating times at low engine speed.
Item Check Page
Brake system/pedal travel Check for proper operation. 59
Parking brake Ensure vehicle does not roll when the parking brake is engaged.
Front suspension Inspect. Lubricate if necessary. Check for loose or missing hardware.
Rear suspension Inspect. Lubricate if necessary. Check for loose or missing hardware.
CV boots Inspect for damage. Replace if necessary.
Steering Check for smooth and free operation.
Tires Check condition and pressure. 50
Wheel hardware Check for loose or missing hardware.
Frame hardware Check for loose or missing hardware.
Fuel and engine oil Check for correct levels. 48
Fluid leakage Inspect vehicle for leaks.
Switches Check operation.
Reverse warning alarm Check operation.
Air filter Inspect; clean or replace if necessary. 57
Headlights Check operation. 52
Brake light / taillights Check operation. 52
Starter / generator belt Check condition. 56
To Next Page
Loading...
