VEHICLE MAINTENANCE
63
1. Clean the vehicle. See VEHICLE CLEANING AND CARE on page 50.
2. Turn the key to the OFF position and put the direction selector in the NEUTRAL position.
3. Chock the wheels to prevent the vehicle from rolling. Do not engage the parking brake.
4. Engage the neutral lock. See Towing the Vehicle on page 62.
5. Perform all required routine maintenance indicated in the SCHEDULED MAINTENANCE CHART on page 46.
6. Fully inflate the tires. See Tire Pressure on page 51.
7. Turn the fuel shut-off valve to the closed (OFF) position.
8. Run the engine until the remaining fuel in the carburetor and fuel lines is depleted and the engine stalls.
9. Disengage the neutral lock.
10. Loosen (do not remove) the carburetor drain screw. Drain any fuel remaining in the bowl into an approved con-
tainer and pour the fuel into the fuel tank. Add fuel stabilizer (4 oz. for a full tank of fuel) to the fuel and install the
cap securely.
11. Tighten the carburetor drain screw.
12. Remove the spark plug and pour approximately 1/2 oz. (15 ml) of SAE 10 - 30 weight oil or fogging oil into the
cylinder.
13. Rotate the crankshaft by hand several times, and reinstall the spark plug.
Remove from Storage
1. Change the oil.
2. Check the spark plug for tightness. Tighten if necessary.
3. Check all items in the daily pre-ride inspection. See PRE-RIDE INSPECTION on page 21.
4. Lubricate according to the SCHEDULED MAINTENANCE CHART on page 46.
To Next Page
Loading...
