CUSTERS CR 700 - Page 17

17
10: Place one platform with hatch (on the
5
th
rung from the top, slide both blow-
away protections under the rung;
11: Lock the brakes and set the
scaffold level by twisting the
spindle nut of the casters;
Now place the four (large or small)
stabilizers:
12: Place the upper coupler under the 6
th
or
7
th
rung at the small leg, 9
th
or 10
th
rung
at the large leg;
13: Put the foot on the ground with
observance of the designated basic form
(see 4.4);
14: Make sure that the lower coupler falls
between two rungs;
15: Rotate the stabilizer in such a way that
the designated basic form (see
4.4) is maintained;
16: Tighten the lower coupler
by hand on the upright and slide the
coupler upwards over the upright so
that the leg is slightly tensioned and
slightly tighten both couplers;
17 Climb to the 2 m. level through the
hatch; sit down in the hatch and mount
two knee rails on the 2
nd
rung and in the
hooks of the Mobile Guardrails and
move them slightly inwards.
18 Now you are allowed to stand on the
platform where you put horizontal
braces on the uprights just above the
2
nd
and 4
th
rung.
10
11
12/16
15
13
13/15/16
18