3
1. Introduction
The Custers® mobile scaffold tower is part of a wide range of aluminium scaffold
variants.
The Custers® mobile scaffold tower, if assembled according to this manual, complies
with the actual standard EN1004-1:2020. Custers Hydraulica B.V. has assessment
documentation as well as certificates to proof the conformity of the Custers® mobile
scaffold system to the actual standards.
The Custers® mobile scaffold tower is available in the following versions:
Scaffold length: Handy & CR 1.8 m & 2.5 m; Handy 3,1 m
Scaffold width: 1.3 m and 0.7 m
This instruction manual is intended to instruct you step by step how to assemble your
scaffold easily and safely. Incorrect assembly may result in serious personal injury.
Read the safety instructions carefully before assembly. The erection and dismantling
should be done by experienced and competent persons only.
This instruction manual shall be available on the location of use of the mobile access
and working tower.
This mobile access and working tower shall only be used according to this manual
without any modification.
Mobile access and working towers shall only be used in accordance with national
regulations
If there are any uncertainties with regard to this manual, please contact your supplier
and/or manufacturer.
Manufacturer:
Custers Hydraulica B.V.
Smakterweg 33
5804 AE Venray, The Netherlands
Telephone: +31 (0) 478 553 000
Email: info@custers.nl
Website: www.custers.nl
Supplier:
To Next Page
Loading...
