1
10: Place one platform with hatch (on the
5
th
rung from the top) on the façade
side and the other platform without
hatch on the other side
11: Slide both blow-away protections
under the rung;
12: Lock the brakes and set the
scaffold level by twisting the
spindle nut of the casters;
Now place the four (large or small)
stabilizers:
13: Place the upper coupler under the 6
th
or
7
th
rung at the small leg, 9
th
or 10
th
rung
at the large leg;
14: Put the foot on the ground with
observance of the designated basic form
(see 4.4);
15: Make sure that the lower coupler falls
between two rungs;
16: Rotate the stabilizer in such a way that
the designated basic form (see
4.4) is maintained;
17: Tighten the lower coupler
by hand on the upright and slide the
coupler upwards over the upright so
that the leg is slightly tensioned and
slightly tighten both couplers;
18: Climb to the next level through the
hatch; sit down in the open hatch;
19: mount two knee rails on the 2
nd
rung
and in the hooks of the Mobile
Guardrails and move them slightly
inwards. Now you are allowed to stand
on the platform where you put
horizontal braces on the uprights just
above the 2
nd
and 4
th
rung.
10
11
12
13/18
14
15/17/18
16
19
To Next Page
Loading...
