1 INTRODUCTION
This document is divided into sections and chapters. Each chapter can be reached by the index at the beginning of this
document. The index can be reached by the button on each page as shown in the diagram below.
5 CONFIGURATION
5.1 Setup parameters
AAAA, BBBB
When the printer is turned on it performs a self-test and reset routine
that checks
and initializes the following electronic and mechanical
components.
When the printer is turned on it performs a self-test and reset routine
(1)
that checks
and initializes the following electronic and mechanical
components.
During
power-up, if the LF LINE FEED key is held down,
the printer enters the autotest routi-
ne and prints out the Setup report.
The printer permits the configuration of default
parameters
.
CCCC
During power-up, if the LF LINE FEED key is held down,
the printer enters the auto-
test routine and prints out the Setup report.
The printer permits the configuration of
default parameters
.
Numbered title
for chapter
Numbered title
for paragraph
Information valid
for devices
AAAA, BBBB, CCC
Information valid
for device CCCC
Information valid
for devices AAAA, BBBB
Generic information or
suggestions for the use
of the devices
Information or
suggestions related to
specific operations
Useful information to
not compromise
devices operation
Link to table of contents
Notes reference
NOTES:
All the dimensions shown in figures are in millimetres.
(1) For the keys functions refer to the chapter 2.
ATTENTION: Respect power supply polarity.
11
To Next Page
Loading...
Need help?
General
