Custom Engineering s'print - Default Chapter; Table of Contents

TABLE OF CONTENTS
i
DPT100-B/I/BT
INTRODUCTION
MANUAL CONTENTS ...................................................................................................................................... 1
EXPLANATORY NOTES USED IN THIS MANUAL........................................................................................... 1
GENERAL SAFETY INFORMATION ................................................................................................................ 1
UNPACKING THE PRINTER ........................................................................................................................... 2
PRINTER FEATURES ...................................................................................................................................... 2
PRINTER DESCRIPTION ................................................................................................................................. 3
1. INSTALLATION AND USE
1.1 CONNECTIONS ..................................................................................................................................... 1-1
1.1.1 Battery recharger ............................................................................................................................ 1-1
1.1.2 Turning the printer On and Off.......................................................................................................... 1-1
1.2 BATTERIES ............................................................................................................................................ 1-2
1.2.1 Recharging batteries ....................................................................................................................... 1-2
1.2.2 Information regarding battery use..................................................................................................... 1-3
1.2.3 Replacing batteries.......................................................................................................................... 1-3
1.2.4 Disposing of batteries ...................................................................................................................... 1-5
1.3 CONFIGURATION ................................................................................................................................... 1-5
1.3.1 Configuration Mod. DPT100-B/I........................................................................................................ 1-5
1.3.2 Configuration Mod. DPT100-BT........................................................................................................ 1-6
1.4 HEXADECIMAL DUMP............................................................................................................................ 1-8
1.5 SIXLOAD ................................................................................................................................................. 1-8
1.6 MAINTENANCE ...................................................................................................................................... 1-9
1.6.1 Changing the paper roll.................................................................................................................... 1-9
1.6.2 Cleaning .........................................................................................................................................1-10
2. INTERFACES
2.1 RS232 SERIAL ....................................................................................................................................... 2-1
2.2 INFRARED BIDIRECTIONAL SERIAL ...................................................................................................... 2-3
2.2.1 Standard Mode ................................................................................................................................ 2-4
2.2.2 InfraRed communication protocol..................................................................................................... 2-4
2.2.3 Printing instructions ........................................................................................................................ 2-5
2.3 IrDA PROTOCOL OVERVIEW................................................................................................................. 2-5
2.3.1 IrDA Data protocols supported ......................................................................................................... 2-7
2.3.1.1 Physical signal layer (PHY) ..................................................................................................... 2-7
2.3.1.2 IrLAP ....................................................................................................................................... 2-8
2.3.1.3 IrLMP ....................................................................................................................................... 2-8
2.3.1.4 Link Management-Information Access Service ......................................................................... 2-9
2.3.1.5 IrCOMM ................................................................................................................................... 2-9
2.3.1.5.1 3-Wire Raw and IrLPT in detail ............................................................................................... 2-9
2.3.1.5.2 How 3-Wire Raw and IrLPT differ ............................................................................................ 2-9
2.3.1.5.3 IAS entry and hint bits...........................................................................................................2-10
2.3.1.5.4 Basic link operation...............................................................................................................2-10
2.4 BLUETOOTH PROTOCOL OVERVIEW (ONLY MOD. DPT100-BT) ........................................................2-10
2.4.1 Protocols supported .......................................................................................................................2-10
2.4.1.1 Serial Port Profile .................................................................................................................... 2-11
2.4.1.2 Object Push Profile ................................................................................................................. 2-11
3. PRINTER FUNCTIONS
3.1 CONTROL CHARACTERS ...................................................................................................................... 3-1