Custom Engineering s'print - Page 52

4. TECHNICAL SPECIFICATIONS
34-
DPT100-B/I/BT
repapmm75ipc7.21
snmulocforebmuN04,42
)3(
)mmHxL(sretcarahC
lamroN3x2
thgiehelbuoD6x2
htdiwelbuoD3x4
htdiwdnathgiehelbuoD6x4
snoitacificepstropderarfnilanoitceridiB
ecnatsidgnitarepO .tm1otpu
htgnelevaWmn009-008
snoitacificepstrophtooteulB
ecnatsidgnitarepO .tm01otpu
noitacificepshtooTeulB
)4(
1.1.srev
ecivedssalCrewoP3
rewoptuptuO )mBd0(Wm1
)zHG(dnaBMSI 5384,2-004,2
dnaBdrauGrewoLzHM2
dnaBdrauGreppUzHM5.3
lennahCelbaliavA97
noitaludoM
tfihSycneuqerFnaissuaG(KSFG
)gniyeK
)dnabesaB(deepSxaMs/bM1
detroppuseliforphtooteulB
)eliforPtroPlaireS(PPS
)eliforPhsuPtcejbO(PPO
(Tab.4.3)
(3)
Note: The 40 column version is downloadable on the Support/Download/Firmware section from
www.custom.it web site.
(4)
Note: Support v. 1.1 of the BlueTooth Specification.
LED safety
The infrared port on the front of the printer conforms to Class 1 for LED devices (light-emitting diode), on the
basis of international standard IEC 825-1 (EN 60825-1). This device is not considered harmful, but the following
precautions should be observed:
• avoid direct exposure of eyes to infrared LED rays;
• remember that infrared rays are not visible;
• do not attempt to observe infrared LED rays with any type of optical aid.