CUTES CT-2000FP-2-022 - Inspection Upon Receiving; Nameplate Information; Example for 5 HP;3 A7 220 V; Inverter Model Information

3
1. Inspection upon receiving ■
Preface
Thank you for choosing the CT-2000FG/ FP inverter unit, this inverter unit is suitable for operating squirrel
cage induction motors. This manual is designed to ensure correct and suitable application. Read this manual
before attempting to install. If any problem occurred when negligence of manual. Please contact our
distributors or sales representatives.
※Application notes
▇ Please do not touch the cercuit boards and components immediately after the poweris was shut down.
▇ Wiring is prohibited when power on, please do not check the components and signal on the circuit
board when operation.
▇ Do not fit capacitors to the output side of the inverter in order to improve the power ratio.
▇ Run a motor that is within the capacity of the inverter unit.
▇ In case of fitting MC between inverter and motor to control motor operation, then the capacity of
inverter must be 6 times the capacity of motor.
Inspection upon receiving
A. Check that the model, the capacity and power voltage specifications are as ordered.
B. Check that no damage has occurred during transportation.
C. Check that none of the internal parts have been damaged or have fallen off.
D. Check that none of the connectors have been damaged or have fallen off.
E. Check that there is no loosening of the terminals or screws of each of the parts.
If said problems occurred when negligence of manual. Please contact our distributors or sales representatives
Nameplate information
Example for 5HP/3A7 220V
Inverter model
Input spec.
Output spec.
Motor capacity
Lot No.
Inverter model information
CT2000 FG – 2 -3A7
CT2000 series
MODEL: CT2000FG-2-3A7
INPUT : 3Φ 220V 50//60HZ 21A
OUTPUT: 3Φ 220V 18A 7.1KVA
Motor:3.7KW/5HP Mass:8.0Kg
LOT NO:
No. Max. Motor capacity
3A7󲕏300 3.7KW󲕏300KW
No. Specification
FG 150% load
FP 120% load
No. Input voltage class
2 AC 200󲕏240V
4 AC380󲕏460V
weight