P/N IM-AR5 Rev. F
© 2017 Johnson Controls. All rights reserved. All specifications and other information shown were current as of document
revision date and are subject to change without notice.
7
1.3 Specifications
Power Source: 120/240 VAC 50/60Hz 1 Amp dedicated circuit.
Batteries: Two 12Vdc 4Ah sealed lead acid batteries connected in series. Use only Genesis/Enersys
P/N NP4-12.
Operating Temperature: 32 to 145* degrees F Humidity 85% non-condensing.
Special Application NAC Output ratings:
Class B – 2 output circuits
Non power limited over current protected
24 Volts D.C. @ 1 Amp each
Class A – 1 output circuit
Non power limited over current protected
24 Volts D.C. @ 1 Amp
Regulated NAC Output ratings:
Class B – 2 output circuits
Non power limited over current protected
24 Volts D.C. @ 100 Milliamps each
Class A – 1 output circuit
Non power limited over current protected
24 Volts D.C. @ 100 Milliamps
Dry Contact Relays:
Available when optional model RB-10, 20, 30 or 40 relay box or RM-5 relay module is
connected to the AR-5. RB relay outputs are programmable and rated 24 Vdc @ 1Amp and
RM-5 outputs are rated 30Vdc @ 5A. The number after RB indicates the number of outputs
provided. The RM-5 has 5 relay outputs.
Transceiver Operating Frequency: 900 MHz band.
Signal to Noise Ratio: Minimum Signal -100.2dBM Maximum Noise -115.3dBM
Antenna Type: Omni, Yagi
Transmission Format: Frequency Hopping – Spread Spectrum.
Dimensions: 10” high, 10” wide, 3 ¼” deep
Enclosure: Powder coated 18 gauge steel
Weight: 14 Lbs.
RB-10, 20, 30, 40 Ratings @ 24Vdc
Standby mA Alarm mA
RB-10 2 110
RB-20 4 220
RB-30 6 330
RB-40 8 440
*Transient operation.
To Next Page
Loading...