CyberPower Ecologic - Page 7

Problem Possible Cause Solution
Circuit breaker button
is projecting from the
side of the unit.
Circuit breaker has
been tripped due to an
overload.
Turn the UPS off and
unplug at least one
piece of equipment.
Wait 10 seconds, reset
the circuit breaker by
pressing the button,
and then turn the UPS
on.
The UPS does not
perform expected
runtime.
Battery not fully
charged.
Recharge the battery
by leaving the UPS
plugged in.
Battery is worn out.
Contact CyberPower
Systems about
replacement batteries
The UPS will not turn
on.
The on/off switch is
designed to prevent
damage from rapidly
turning it off and on.
Turn the UPS off. Wait
10 seconds and then
turn the UPS on.
The unit is not
connected to an AC
outlet.
The unit must be
connected to a
110/120V 50/60Hz
outlet.
The battery is worn
out.
Contact CyberPower
Systems about
replacement batteries
Mechanical problem.
Contact CyberPower
Systems
The frequency is
outside of the
operating range of 47-
63Hz.
Turn the UPS off.
Make sure the
frequency range is
within 47-63Hz. Or you
can turn the UPS on in
battery mode.