PR3000
Guaranteed Uninterruptible Power Supplies
21
repairs will take place, and CyberPower must be notified and approve any repair facility before
any Connected Equipment is serviced. Any repair or modification of the Connected
Equipment or the Product by a facility or entity not approved by CyberPower voids this
Connected Equipment Guarantee. If CyberPower determines, in its sole discretion, that it is
impractical to ship the damaged equipment to CyberPower, CyberPower may designate, in its
sole discretion, an equipment repair facility to inspect and estimate the cost to repair such
equipment. The cost, if any, of shipping the equipment to and from such repair facility and of
such estimate shall be borne solely by the Initial Customer. Damaged equipment must
remain available for inspection until the claim is finalized. Whenever claims are settled,
CyberPower reserves the right to be subrogated under any existing insurance policies the
claimant may have.
CONDITIONS COMMON TO THE LIMITED WARRANTY AND THE CONNECTED
EQUIPMENT GUARANTEE
The Limited Warranty and the Connected Equipment Guarantee are the only and the
exclusive express warranty of CyberPower with respect to the Product. This exclusion of other
express warranties applies to written and oral express warranties.
State or Provincial law may adjust the terms of the Limited Warranty or the Connected
Equipment Guarantee or the State or Province may impose additional obligations, or
additional "implied warranties." To the extent necessary to comply with those laws, the terms
of the Limited Warranty and the Connected Equipment Guarantee should be read to adjust to
those requirements only to the extent necessary to comply with such local law.
The Limited Warranty and the Connected Equipment Guarantee Do Not Apply Unless
The Initial Customer:
1. Has properly connected the Product and the Connected Equipment to properly wired
and grounded outlets (including compliance with electrical and safety codes of the most
current electrical code (ANS/NFPA 70), without the use of any adapters, extension cords of
other connectors.
2. Has provided a suitable and proper environment for use and installation of the Product
and Connected Equipment.
3. Has properly installed and operated the CyberPower Product and Connected equipment.
4. Has operated the Product at all times within the limitations on the Product’s VA capacity
as stated in this User Manual.
CyberPower Does Not Cover or Undertake Any Liability in Any Event for Any of the
Following:
1. Loss of or damage to data, records, or software, the restoration of data or records, or the
reinstallation of software.
2. Damage from causes other than Power Disturbances (as defined above) on an AC
Power Line on properly installed, grounded and code-compliant 120 volt power lines in the
United States and Canada; or a Power Disturbance on standard telephone land lines, PBX
telephone equipment lines, Ethernet lines, or coaxial cables when properly installed and
connected.
To Next Page
Loading...
Need help?
General
