CyberPower RMCARD400 User Manual

7
Step 2. Configure the IP address for the CyberPower Remote Management
Card
Note: These instructions are for Windows OS. For other OS please refer to Appendix 4.
Method 1: Using the Power Device Network Utility 2
1. Install the Power Device Network Utility available for download at
www.cyberpower.com.
2. After installation completes, run the Device Network Utility
3. The main window of the Power Device Network Utility program is shown in Figure 1.
The configuration tool will display all CyberPower Remote Management devices present
on the local network subnet. The "Refresh" button is used to search the local network
subnet again.
Figure 1. The main window of the Device Network Utility program.
4. Select the Remote Management Card you are setting up. Click on the Tools menu
and select the Remote Management Card you want to configure. Then, click the
"Connection" button on the top tools list to set up.

CyberPower RMCARD400 Specifications

General

Brand	CyberPower
Model	RMCARD400
Category	UPS
Language	English