To Next PageTo Next PageWhat to do if I am unable to access the Web Interface of my CyberPower UPS?
If you're unable to access the Web Interface for your CyberPower UPS, first ensure that you can ping the RMCARD. Also, verify that you are entering the correct URL. Finally, confirm that HTTP/HTTPS access is enabled by logging into the card via CLI (Telnet or SSH client).
Why can't I ping the Remote Management Card on my CyberPower RMCARD400?
If you're unable to ping the Remote Management Card of your CyberPower UPS, use method 1 and/or method 2 to set a correct IP address for the Remote Management Card. If the PC being used is on a different network subnet from the Remote Management Card, verify the setting of subnet mask and the IP address of gateway.
How to troubleshoot IP address configuration issues on a CyberPower UPS Remote Management Card?
If you're having trouble configuring the Remote Management Card IP Address on your CyberPower UPS, check the LED status. It is normal when the yellow and green LEDs are both on. If the green LED is off, check if the Remote Management Card is properly seated in the device and the device has power. If the yellow LED is off, ensure the network connection is good. Also, ensure the PC being used is on the same local network subnet as the CyberPower device you are trying to communicate with and ensure the Jumper on the Reset Pin is correctly installed.
What to do if my CyberPower UPS is unable to receive traps?
If your CyberPower UPS is unable to receive traps, ensure that the trap types (SNMPv1/SNMPv3) and trap receiver are configured correctly. Also, ensure the IP address of the gateway is correct.
Why am I unable to operate a SNMP get/set on my CyberPower UPS?
If you're unable to operate an SNMP get/set on your CyberPower UPS, verify the community name for SNMPv1. For SNMPv3, verify the user profile configuration.
General| Interface Port | RJ45 |
|---|---|
| Product Type | UPS Management Card |
| Device Type | UPS Management Card |
| Compatibility | CyberPower UPS |
| Network Interface | Ethernet |
| Management Protocols | HTTP, HTTPS, SNMP, Telnet |
| Power Management | Remote monitoring and control |
| UPS Dimensions | 3.5 x 19 x 20.5 inches |
| UPS Weight | 45.2 lbs |
| Warranty | 2 years |
