EasyManuals Logo

CYBEX ATON User Manual

CYBEX ATON
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
When using the Base
Before attaching the Infant Carrier, always check the
Level Indicator for the correct recline angle based on
child's weight.
Vehicle must be on a level surface for the Level
Indicator to function correctly.
To Adjust Angle
1. Uninstall Base. Squeeze the Level Adjustment
Handle to raise or lower the Leveling Foot. Release
handle when the Base is at the correct angle.
2. Check to see if the recline angle is correct
after you have installed the Base.
If the Recline Angle is not correct after installation,
uninstall the base, adjust Leveling Foot and
reinstall.
It's very important for your child's safety that this child restraint be installed at the correct angle.
DO NOT use this or any other child restraint with a premature, low birth weight, or medically
fragile infant, until after you have consulted with your doctor. Some infants may have dif culty
breathing or have other medical problems when placed in a seated position.
If the child restraint is TOO UPRIGHT, the child's head may fall forward and cause breathing
problems. If the child restraint is TOO RECLINED crash protection will be reduced.
FAILURE TO properly recline the child restraint on the vehicle seat increases the risk of DEATH or
SERIOUS INJURY.
22–32 lb
10–14,5 kg
4–22 lb
1,8–10 kg
22–32 lb
10–14,5 kg
4–22 lb
1,8–10 kg
22–32 lb
10–14,5 kg
4–22 lb
1,8–10 kg
22–32 lb
10–14,5 kg
4–22 lb
1,8–10 kg
OR
36
Adjusting the Recline Angle

Table of Contents

Other manuals for CYBEX ATON

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CYBEX ATON and is the answer not in the manual?

CYBEX ATON Specifications

General IconGeneral
Product colorBlack
Recommended age (min)- yr(s)

Related product manuals