6. Install compression spring and top guide rod cap onto guide rod. Slide spring loaded top guide rod cap down guide rod until cap
is clear of guide rod plate and install. Repeat for opposite side.
Item Description Qty
1 Top guide rod cap 2
2 Guide rod 2
3 Guide rod plate 1
7. Install four Phillips head screws securing plastic mount to guide rod plate.
Apply weight plate decal (if not already installed on weight plates)
1. Peel o half of backing from weight plate decals, making sure that the decals remain attached to the front sheet.
Item Description Qty
1 Backing 1
2 Front sheet 1
3 Weight decals 1
2. Place decals front sheet in the correct position on weight plates.
3. Insert a guide pin through each hole of the decals front sheet. (A guide pin can be anything that fits through the weight stack hole,
such as a weight stack selector pin.)
4. Align decals and rub them onto weight plates.
Page 12 of 22
To Next Page
Loading...
