5. Remove front sheet, do not peel decals o of weight plates.
Item Description Qty
1 Weight stack selector pin 1
2 Weight plate decals 1
6. Repeat above steps for other half of the weight plate decals.
Belt routing
1. Verify belt is routed through top of pulley bracket and then route end of belt down to the top weight.
2. Li top weight and verify that the position of the belt clamp (on the top weight) is aligned properly with the top pulley bracket.
3. Slide belt through slot in belt clamp.
4. Verify belt and insert are installed properly. Do not install the insert backwards.
Correct belt routing Incorrect belt routing
Item Description Qty.
1 Belt 1
2 Insert 1
3 Belt clamp 1
5. Pull belt tight and secure belt to clamp with set screws.
6. Torque set screws 300-350 lb-in.
7. Turn the Increment Weight Adjusting Knob to select 0 lbs or 0 kg.
8. Place weight stack pin in each plate to verify proper installation.
9. Simulate normal operation by liing top weight up and down without selecting any resistance.
10. Verify that the belt is moving smoothly and is routed straight from the top pulley bracket to the top weight belt clamp.
Install back panel
Slide back panel down into extrusions.
Page 13 of 22
To Next Page
Loading...
