QtyDescriptionItem
2Foot Pads1
Visually Inspect Unit
1. Remove any packing material from unit.
2. Examine the unit to ensure that the assembly is correct and complete.
Level Unit
This procedure will level the unit by evenly adjusting the weight on the rear feet. Leveling the unit will eliminate
rocking during use.
NOTE: References to left and right are from the users perspective during use.
1. Verify foot plates are completely stopped.
2. Grasp one of the rear covers and slowly lift the rear foot off the floor. Lower rear foot to the floor.
Qty.DescriptionItem
2Rear Cover1
1Left Rear Foot2
1Right Rear Foot3
Lift Here4
Page 40 of 47
To Next Page
Loading...
