EasyManuals Logo

CYBEX R Series User Manual

CYBEX R Series
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #43 background imageLoading...
Page #43 background image
AnnuallyMonthlyWeeklyItem
InspectCleanFrames
InspectInspectCleanPlastic Covers
Clean / InspectLifepulse Sensors
InspectCleanFoot Plates
Inspect / AdjustLeg Levelers
Troubleshooting the Polar
®
Heart Rate Chest Strap
Heart rate reading is erratic or absent entirely
Corrective ActionProbable Cause
Wet the belt transmitter electrodes.
Belt transmitter electrodes are not wet enough to pick up accurate
heart rate readings.
Ensure the belt transmitter electrodes are laying flat against the
skin.
Belt transmitter electrodes are not laying flat against the skin.
Wash the belt transmitter with mild soap and water.Belt transmitter needs cleaning.
Setup of the belt transmitter is accomplished by initially bringing
it with in 1 foot of the receiver. The receiver is in the console. After
the heart rate is displayed on the console the range is extended to
3 feet.
Belt transmitter not properly set up.
Contact Customer Support Services for instructions on how to have
the chest strap replaced.
Chest strap battery is depleted.
Abnormally elevated heart rate readings
Corrective ActionProbable Cause
Move the exercise equipment a few inches away from the probable
cause, or move the probable cause a few inches away from the
exercise equipment, until the heart rate readings are accurate.
Electromagnetic interference from television sets and/or antennas.
Electromagnetic interference from cell phones.
Electromagnetic interference from computers.
Electromagnetic interference from cars.
Electromagnetic interference from high voltage power lines.
Electromagnetic interference from motor driven exercise equipment.
Troubleshooting the Lifepulse
System Sensors
If the heart rate reading is erratic or missing, do the following:
Dry the hands if necessary to prevent slipping.
Apply hands to all eight sensors on user arms or bullhorns.
Grasp the sensors firmly.
Apply constant pressure around the sensors.
Drive Belts
Remove Front Access Cover
1. Remove screws securing front access cover using a Phillips screwdriver.
Page 43 of 47

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CYBEX R Series and is the answer not in the manual?

CYBEX R Series Specifications

General IconGeneral
BrandCYBEX
ModelR Series
CategoryExercise Bike
LanguageEnglish

Related product manuals