OUTER SEATING POSITIONS
Use the lower LATCH anchors OR a vehicle seat belt to install
the Child Restraint in outboard seating positions (those on either
side of the center position)
CENTER SEATING POSITIONS
If your vehicle does not have lower LATCH anchors in the center
seating position, check your Vehicle Owner’s Manual to see if
you are allowed to use the two inner lower LATCH anchors from
the outboard seating positions to install a Child Restraint.
CYBEX allows this Child Restraint to be installed using the two
inner lower LATCH anchors from the outboard seating positions if
the distance between the inner lower LATCH anchors is between
11 and 20 in. (28 - 51 cm) AND if your vehicle manufacturer
allows it. (If distance is not correct and/or not allowed by vehicle
manufacturer, use the vehicle belt for installation in the center
position.)
When using the inner lower LATCH anchors make sure there
are no obstructions from a buckle stalk for the installation or that
the LATCH Straps or mini connectors do not block vehicle belt
buckles.
USING LATCH GUIDES
1. Locate the lower LATCH anchors or the symbols indicating their location.
2. If the lower LATCH anchors are hidden behind the crease between
the seat back and seat cushion, install the supplied LATCH
Guides to the lower LATCH anchors for easier installation.
3. To install, connect the two LATCH Guides to the two lower LATCH anchors by
sliding the LATCH Guides into the crease and under the lower LATCH anchors.
11-20 in.
2625
USING LATCH USING LATCH
To Next Page
Loading...
Need help?
General
