3. Place Child Restraint rear-facing on selected vehicle seat. Make sure it is not
blocking the vehicle belt buckle.
4. Installation on Level Ground: Locate the Level Indicator label and readjust the
seat recline to any position that the ball falls within the blue zone for
REAR-FACING installation.
5. Installation on a Slope: Locate the Level Line on the blue label near the
Rear-Facing Belt Path. Adjust the seat recline so that the Level Line is level
with the ground.
Installation Options:
*LATCH installation
continued on page 33.
*Lap/Shoulder Belt installation
continued on page 37.
*Lap Belt Only installation
continued on page 39.
1. Make sure the vehicle is on level ground, if possible.
2. Squeeze the Recline Adjustment Handle
a
on front of Child Restraint and pull
forward to adjust to a reclined position as shown
b
. Only use recline positions
1 through 6 for rear-facing use.
Do not use Tether in REAR-FACING mode.
Tether must be properly stored - See "Tether Storage" page 16.
Infants may have difculty breathing when in an upright seated
position. Make sure they recline enough for their head to lie back
comfortably and safely. Failure to properly recline the Child Restraint
could increase the child’s risk of serious injury or death.
3231
To Next Page
Loading...
Need help?
General
