CHECK YOUR WORK
• HOLD Child Restraint at each side near Rear-Facing Belt Paths. Pull side to
side and forward. Child Restraint should not move more than 1 in. (2.5 cm) from
vehicle seat back or side-to-side.
• Make sure Child Restraint is level for rear-facing use (p. 31-32). Make sure
child's head does not fall forward. If necessary, loosen the vehicle belt, readjust
recline and repeat installation steps to make sure Child Restraint is installed
properly.
• Check installation before every use.
The Lock-Off provides a way to lock the Child Restraint without needing to lock
your vehicle seat belt.
1. Route vehicle lap/shoulder belt through the blue Rear-Facing Belt Path on the
side of the Child Restraint.
2. Route the vehicle belt under the Seat Cover.
For Infant and Toddler use, route the vehicle belt in front of the Crotch Strap
a
.
For Child use, route the vehicle belt behind the Crotch Strap
b
.
Note: See page 28 for proper Crotch Strap adjustment. The Crotch Strap
should ALWAYS be as close as possible to, but NEVER under, the child's
bottom.
3. Pull vehicle belt down through the blue Rear-Facing Belt Path on opposite side
of the Child Restraint. Buckle the vehicle belt.
Note: Before tightening the vehicle belt, route the shoulder belt through the
Lock-Off.
4. While pushing down on the Child Restraint
c
, pull the vehicle shoulder belt
d
to
tighten the vehicle lap belt.
5. Continue to pull on the vehicle shoulder belt and position the shoulder belt in the
middle of the Lock-Off area. Lock-Off will not function properly if the vehicle belt
is not positioned properly.
6. Reattach Seat Cover.
3837