CYBEX Sirona M User Manual

Place belt here.
CHECK YOUR WORK
• HOLD Child Restraint at each side near Forward-Facing Belt Paths. Pull side to
side and forward. Child Restraint should not move more than 1 in. (2.5 cm) from
vehicle seat back or side-to-side.
• Make sure ball is between lines on label for forward-facing use (p. 41-42).
If necessary, loosen the vehicle belt and Tether, readjust recline and repeat
installation steps to make sure Child Restraint is installed properly.
• Check installation before every use.
4. While pushing down on the Child Restraint
a
, pull the loose end of the vehicle
lap belt
b
to tighten.
5. Locate Tether anchor in your vehicle. Attach Tether Hook. Pull Tether Adjuster
Strap to tighten.
Note: The Lock-Off is for lap/shoulder belt systems only and is not needed for lap
belt only installation.
1. Remove Tether from Tether Compartment. Route vehicle lap belt through the
red Forward-Facing Belt Path on the side of the Child Restraint. Lift the Seat
Cover on the back of the seat and pull the vehicle belt through the opening on
the side of the Child Restraint.
2. Pass the vehicle belt along the back of the Child Restraint as shown.
3. Pull vehicle belt down through the red Forward-Facing Belt Path on the opposite
side of the Child Restraint. Buckle the vehicle belt. Replace the back of the Seat
Cover after tightening.
5049
1
2
3
4
5
6
7
8
9
10
2
3
10
9
8
7
6
5
4
3
2
1
1
5
4
1
2
3
4
5
6
7
8
9
10
1
2
3
4
5
6
7
8
9
10
CLICK!
CLICK!
a
b
INSTALL FORWARD-FACING USING LAP BELT ONLY INSTALL FORWARD-FACING USING LAP BELT ONLY
EN
FORWARD-FACING

CYBEX Sirona M Specifications

General

Model	Sirona M
Category	Convertible Car Seat
Forward-Facing Weight Limit	22-65 lbs
Installation Type	LATCH or Vehicle Seat Belt
Orientation	Rear-Facing and Forward-Facing
Harness Type	5-point harness
Warranty	2 years
Height Limit	Up to 49 inches
Safety Features	energy-absorbing shell
Adjustable Headrest	Yes, 12-position